-
Not sure if this is the best place to post this issue. If you do a refresh or v2 of the PCB, please note that the silkscreen for the X and Y axes are reversed. According to the datasheet, X should poi…
-
On back silkscreen, there is text "I2C address: 0x70 + ... 4 2 1 where R=39k... ", with the numbers 4, 2 and 1 corresponding to R2, R3, R4 and R5, R6, R7.
But the assignment is wrong. R2 and R5 do …
-
Candidates:
* https://fonts.google.com/specimen/VT323?category=Monospace&preview.text=USB%20BOOT&preview.text_type=custom
* https://fonts.google.com/specimen/Roboto+Condensed?category=Sans+Serif,D…
-
Nice plugin! It would be great if it would work as a toggle. Then one could hide the silkscreen designators and show them again if needed. I mean instead of this:
```
# Hide reference
reference = …
0xDP updated
3 months ago
-
While top side of all modules is pretty busy we have the rear side very very empty
Shall we name and version all modules on the back of the PCB?
-
I've been using tracepsace for reading Gerber files generated by kicad v7, and ran into an issue with this file in particular. I've attached the offending Gerber file as well as the source kicad PCB.
…
-
- [ ] ~~C3 connection randomly dying~~
- [x] trackball FPC to VIK standard
- [x] add tht breakout for additional pins (DEV Zone)
- [x] open jumper between rp2040 pin and 4th trrs pin - use GPIO12 …
bstiq updated
2 months ago
-
Great ESPHome lib! I ordered the PCBs, installed the code and now got it working on my 2 HVAC units :-)
I think this one is for @florianbrede-ayet
First thumbs up for making the PCB! I've got a…
-
It seems like currently for KiCad export, only F.Cu and B.Cu layers are exported. But other layers are also important, for example board edge (Edge.Cuts) and silkscreen (F.SilkS or S.Silkscreen depend…
-
Hello,
Please add gerber file detection according to the Gerber X2 Specification:
e.g.
Top copper:
%TF.FileFunction,Copper,L1,Top,Signal*%
Top soldermask:
%TF.FileFunction,Soldermask,Top*%
Bo…