-
Well.. my arduino sketch contains this code:
```c
void setup() {
Serial.begin(115200);
}
```
And my first try in Python looks like this:
```python
from pysimavr.sim import ArduinoSim
p…
-
I'm interested in adding support for the new AVR chips, 0/1/2-series tinyAVR and megaAVR, that have been released in the past few years. While overall the cores look a lot like classic AVR cores, ther…
-
I want to use simavr for simulating atmega328p which runs at 16MHz.
When specifying 16000000 for AVR_MCU, I get an overflow error for AVR_MCU_LONG.
` AVR_MCU( 16000000UL, "atmega328p");`
Compi…
-
Hi,
When doing a write transaction, I'm getting the wrong status in TWSR after sending the address. I'm reading 0x28 which stands for data write w ack, I was expecting 0x18, sda+w w ack, which is als…
20Mhz updated
3 years ago
-
I noticed that this project reserved the crate embassy-avr: https://lib.rs/crates/embassy-avr Does this foretell AVR support in the near future?
-
### Steps To Reproduce
Steps to reproduce the behavior:
1. build `pkgs.xquartz` (in this case I added it to `environment.systemPackages` with nix-darwin, but the same thing happens with `nix-shell…
-
Hello,
as the IRC seems dead i try it here: What's the correct way to set an external pin state for an input, like if the AVR-pin is connected to some other device? Is AVR_IOCTL_IOPORT_SET_EXTERNAL…
-
Hi,
Prusa-Firmware merged **UPDATE** https://github.com/prusa3d/Prusa-Firmware/pull/3021
As you are using the `M73` in your Octoprint Plugin please verify if it will still work after the new Prusa-F…
-
I have the following code, reduced as far as I could:
```
#include
#include
#include
#define nanowait() _NOP()
int main ()
{
/* Input trigger: PD0 */
DDRD |= _BV(DDD0);
…
-
Spent a few hours trying to figure out what I was doing wrong with my code. #210 hinted at the problem but ultimately: there's no USI support.
Granted, this is not listed in the README.md on the f…