-
### Description
Can't send file by esp3d. M28 command not working. SKR MINI E3 V.2.0 + TFT35 E3 V3.0
Error:No Checksum with line number, Last Line: x (where x is a int value)
### Steps to repro…
-
I have done this a few times by accident when gettign confused when switching different boards. So, the only issue I can find is that all 3.3v pins are shorted to ground, and that includes all the cap…
-
I compiled marlin firmware on skr mini e3 v3 and the relay when i switch on the relay goes from on to off, then i have to press the reset button then it comes on and stays like that. Is it normal ?
-
I just cant make homing to work. I have installed BLtouch and I upload this firmware and still when I pres homing
it moves X and Y and Z goes up a bit and that is all. First I try with marlin I compi…
-
Hello I have installed a SKR Mini E3 V3.0 it works fine with standard Ender screen on my Ender 5 Pro. But when I fit an TFT 35 e3 v3 the print stops printing, this happens at various times during pri…
-
tried downloading new firmware to my ender 3 and now I’m just getting a blue screen and it’s not coming on can anyone help me please
i have the skr mini v2 and bl touch
i had it working then the l…
-
I just added a Skr mini E3 V3.0 as a seecond mcu in klipper connected via usb to my rpi 4b
Everything works fine until i restart the machine and it wont let boot the rpi, if I disconnect it it boot…
-
Hi,
at first sorry for my bad english :) I am now the proud owner of the following products. I would like to connect the BTT Smart Filament Sensor and a BLTouch and a TFT35 E3 V3.0 to the SKR mini …
-
Hey there!
First off, thanks for putting this out there @fryc88! Long story short, I was going to Klipperize my Sovol SV01 Pro, but hit an issue on the last print that I did before that. The part…
-
Hello, I have been trying to get my Alfawise U30 with a bltouch working but always get a bl touch error. I have tried many different marlin configs but nothing works. The only thing that kinda started…