-
You use 12v stepper motors. Try motors which are spec'd at 3 to 4v.
Those 12v stepper motors are inappropriate for 3d printers/plotters etc.
I have a bunch of 12v steppers and they collect dust in …
-
Do you know what the relative torque is for the smaller stepper motors from aliexpress? https://www.aliexpress.com/item/2054451318.html
I bought a few stepper motors from stepperonline that are rat…
-
Hello,
when there is no action and the motor is idle, it continuously clicks and get fairly warm after a while. The led on the driver pcb rotate showing it's active but not moving. Any way to stop …
-
i just stumbled on the new *Stepper-Motor* Mode options - and then found that these are currently only available when you manually install the library (download, unzip, move to arduino library folder.…
-
following error happens when i try to use autotune with fysetc-42HC40-204A-300N84:
`TMC 'stepper_z' reports error: DRV_STATUS: 40150010 s2vsa=1(ShortToSupply_A!) cs_actual=21 stealth=1`
the motors…
-
Hi, i try to play around with a NEMA34 and the BIGTREETECH TMC5160T Pro board. It looks like i hooked up evrything correctly but i still cant get the motor spinning. I cant turn the shaft of the motor…
-
I am using a Filametrix on a standard bedslinger (OG Ender 3) but the X axis stepper skips at normal printing current.
I have edited the MMU_CUT_TIP macro to adjust my stepper current before and a…
-
Is this suport 4 corner actuactor, withsurge and 2 TL rear and front?
I want to used simhub motion.
And it suport step/dir??
Iam planing to try first with stepper motor. Bacause iam project make…
-
What is the best way to interface with closed loop stepper motor?
Currently I working on simple design for closed loop stepper comntroller that can be very cheap but will its work. So basicaly it i…
-