-
**Describe the bug**
Zephyr assertion is triggered by UART reception when asynchronous API is used.
The event flow is as described below:
1. System timer ISR starts handling IDLE timeout (submitred…
-
**Describe the bug**
During ble scan the BT RX thread hangs on and ble scan callback is not fired. This happens at random time after scan start.
**To Reproduce**
Example: bluetooth/scan_adv
west…
-
I am limited to 150-180 bytes/s on the transfer speed when I write data from the STM32WB55 to a RPI with read and notify.
I have tested different timings for when the device poll and the advertising…
-
**Describe the bug**
With the latest Zephyr bt_disable() function was added to shutdown the BLE subsystem. It works properly on STM32WB55 and nRF53, but not on nRF52. After this sequence: bt_enable()…
-
Calling these functions is very important, since only then the debug register and breakpoints are cleared.
-
**Is your feature request related to a problem? Please describe.**
The new HAL(v1.1.14) for stm32wb is released and it should support BLE extended advertising in Zephyr while using firmware stm32wb…
-
**Describe the bug**
Building with the `-m32` argument in CFLAGS & CXXFLAGS causes the build to throw a struct packing assertion
**To Reproduce**
Steps to reproduce the behavior:
1. Clone this r…
-
**Describe the bug**
Running Bluetooth application with SMP in peripheral mode.
When connected to from remote device errors codes are received indicating that connection procedure failed.
However t…
-
**Describe the bug**
Following pinctrl pin definition for STM32WB55 does not set pin as push-pull (and sets pin as digital input):
```
/omit-if-no-ref/ pph_rst_init: gpio_pb0 {
pinmux = ;
…
-
**Describe the bug**
tests/drivers/adc/adc_api test fails when running on
- nucleo_wb55rg
- stm32l562e_dk
Test execution blocking in the first sequence _test_adc_asynchronous_call_
Pleas…