-
A sensor interface needs to be provided for the inertial sensor module:
https://www.st.com/resource/en/datasheet/lsm6dso32.pdf
You can find more information about how the avionics hardware team …
-
SBSFU Application does not build. According to the readme.html found in SBSFU application root folder:
_In order to build the SBSFU_Appli Secure and Non Secure projects, you must do the following:
…
-
**Describe the bug**
STM32 core allows user to define some value by adding a build_opt.h file at sketch level.
This file is not a standard header file as it is used by the gcc command line with `@fi…
-
Hello,
I have been studying the pqm4 code and I have a doubt about the random number generator (specifically for STM32F4 board, as hardware RNG varies for each board).
I see that random number …
-
We were discussing how the stm32U5 could be exciting for future developments; here it is as a test board FYI :) :
https://no.mouser.com/ProductDetail/STMicroelectronics/NUCLEO-U575ZI-Q?qs=Wj%2FVkw3…
-
The EBB can be put in dfu mode and the file upload works. It does not show up with lsusb after a reset. This is with both the pre built and compiled firmwares.
-
**Describe the set-up**
STM32H7B3I-EVAL
STM32CubeIde 1.11.2
This is an error rather than a bug.
In https://github.com/STMicroelectronics/stm32h7b3i-eval-bsp/blob/main/stm32h7b3i_eval_camera…
-
Hi, I noticed some strage behaviors with output of [`ism330dhcx_from_lsb_to_nsec`](https://github.com/STMicroelectronics/stm32-ism330dhcx/blob/97d7566cfdca7ab47e26f5af2fd912ec4531408b/ism330dhcx_reg.c…
-
Is it possible to work with a 7" LCD display, a Kernel 3.4 Debian or lubuntu kernel 4.4 and a single board computer called FriendlyARM NanoPi?
You know which chip from STMicroelectronics is used? …
-
some level of water proofness is desired
we have calibration via CAN and firmware _update_ via CAN
how do we use main connector even for initial programming? would we have to expose BOOT pin and…