-
The TCXO control voltage is hard coded in set_oscillator to be 1.7V, but it's normally configurable because different radios use different voltages.
It would be nice to have it controllable.
I'm…
-
# Background
I have taken the LoRaWAN example and managed to connect to TTN.
I have set up two devices in TTN to test this issue for APB mode and OTAA mode respectively.
Using the LoRaWAN MAC…
-
My board is very simple - Arduino UNO chip and crystal with no regulator or serial interrace - battery powered. I made two changes to your transmit example without interrupts: pin assignments to mat…
-
Using the E5 dev board (https://www.seeedstudio.com/LoRa-E5-mini-STM32WLE5JC-p-4869.html), I can get chirpstack to recieve a JoinRequest and issue a JoinAccept however RadioLib provides a timeout erro…
-
I am using the library (5.7.0) for the first time and face an issue with the ebyte module E22M900M22S connected ton ESP32 module (Adafruit Huzzah).
First I had to modify the example to include the …
-
After v.5.7 the ebyte sx1262 chips aren't identifying (-2 error) and code takes much more space.
I'm switching back to 5.6 which has worked fine.
-
The packet forwarder refuses to start with the following error -
```
sx1302_hal *** Packet Forwarder ***
sx1302_hal Version: 2.1.0
sx1302_hal *** SX1302 HAL library version info ***
sx130…
-
This would ensure we can run the gw as a helium packet forwarder and an egw PoS miner.
h0bb3 updated
7 months ago
-
When using RadioLib 6.0.0, calling `int state = radio.receive(str);` results in a negative -705 error. When changing the library to version 5.7.0, and nothing else, receive works as expected. Receive …
-
Hi All
I am running the my experiment on Raspberry 4B and I could register the gate to the ttn, however when I tried to run the (test_loragw_hal_rx and test_loragw_hal_tx) I got this error (ERROR: …