-
Ardupilot can do passthrough serial as well and if configured manually (holding the boot button and setting the passthrough manually) has worked for a user so 420000 baud passthrough should work.
N…
-
If a gateway receives a weak signal (low RSSI < xxx dBm), the gateway will replay the packets again for nearby gateway.
Or to have fwd_id in the packet to route the packet to the wanted gateway.
-
[1] Duplicated LoRa_MOSI, No LoRa_MISO
[2] Is there OLED_RST or LORA_RST or BOTH wired to ESP32 PICO D4?
[2] OLED (SDA, SCL) and other LoRa (IRQ/DI0) pin mapping are unclear due to the two new pull …
fedy0 updated
5 years ago
-
### Hardware
Seeed Card Tracker T1000-E
### Firmware Version
2.5.0
### Description
As discussed in Discord over the past 3 weeks, there are multiple instances of people reporting issues…
-
I can compile your sample, but when i try to upload the upload fails.
I'm using this programmer: [https://www.amazon.ca/DSD-TECH-Adapter-FT232RL-Compatible/dp/B07BBPX8B8](url)
the programmer is set…
-
**Is your feature request related to a problem? Please describe.**
A clear and concise description of what the problem is. Ex. I'm always frustrated when [...]
No support voor de ESP32 C3 (mini)…
-
Hello and thank you for creating this library! When configuring the LoRa gateway with a bandwidth of 62 kHz or below, I am experiencing issues where the gateway is not receiving messages as expected. …
-
I connected a bme280 thermometer to the Pi zero, but Wenet now gives an error, and it doesn't work. I tried removing the thermometer, formatting the SD card, but I can't solve the problem. Suggestions…
-
I am trying to communicate two devices. One broadcasting based on Ra-02 Aithinker SX1278 433MHz using arduino-LoRa library (demo sender).
https://www.disk91.com/2019/technology/lora/first-steps-with…
-
Hi,
How to compile and use this library with raspberry pi. Please specify