-
**Describe the bug**
I set the iron to startup in soldering mode.
After powering it shows the actual temperature but does not heat up. After some seconds it shown "thermal runaway".
After some more…
-
the documentation is very fragmented, and there is no single document that describes this wonderful software's features.
the right way to do this is to have embedded in the source code structured c…
-
### Issue
Unable to update firmware on my TS80 through USB transfer or dfu-util.
Saw in another thread that a 'static'/dots screen may be a hardware issue, and my TS80 has done that for a long t…
zlice updated
2 years ago
-
**Describe the bug**
When I start the soldering iron it shows "accelerometer not found". The sensitivity is automatically set to zero in the settings.
**To Reproduce**
1. Turn on soldering iron.…
CvRXX updated
2 years ago
-
I tried the IronOS firmware on my TS80P for the first time.
In the source code I saw that the QuickCharge3 Continuous Mode is supported. But how can I use this to trigger a voltage higher than 12V.
…
-
What's about with PPS support, i can't find any info documenting it. If it's not supported will it be supported and if it's supported how stable is it?
-
**Describe the bug**
The 'scrollbar' is in some registers not using the whole area it should, hence its length is not right either.
**To Reproduce**
Steps to reproduce the behavior:
1. Go to the…
-
Hello. I am having some problems with the temperature reading on the displays. If I use a TS-B02 tip and set the temperature to 330 degrees, then on the displays it jumps sharply from 330 to 340, an…
-
I tried this on OSX Big Sur as well as Windows 10. When mounting the iron per these instructions:
https://github.com/Ralim/IronOS/blob/master/Documentation/Flashing.md
... I get the following er…
-
When I power my TS80 iron from a regular USB charger it works fine, but every time I try to power it from type-c charger it does not work at all. I have tried three of them: 100w Macbook pro, and two …
Fxlr8 updated
3 years ago