-
“You can use an M3 fastener to temporarily fix them in place and prevent **the** from sliding out of the slot.“
On a related note, any plans to make the docs source open? Is there a way to contribu…
-
![v0 2r1-p231](https://github.com/VoronDesign/Voron-0/assets/65358226/499d1b00-b472-4242-be1c-1536bd9052d3)
-
As the title suggest, I think a solution for RGB NeoPixels mounting instead of sequins leds would benefit the community.
shkup updated
8 months ago
-
85: Bottom left image calls out one M3x35 BHCS ("front screw") that was installed into the part on page 84.
86: Bottom left image calls out one M3x35 BHCS ("front screw") that was installed into the …
Kagee updated
8 months ago
-
For the filament sensor the pressed switch is the CONTINUE/RUN condition, while a non-pressed switch is the ERROR/STOP.
For endstops this is reversed. A pressed switch is the ERROR/STOP condition,…
Kagee updated
8 months ago
-
V0.2r1 manual page 102: Swap left/right image/instruction to follow common left-right reading order
Kagee updated
8 months ago
-
Make a note in the PDF that the front feed are not identical, but mirrors of eachother, so user does not go looking for two front right feet (pictured in the manuel), since the holes for the self-tapp…
Kagee updated
8 months ago
-
V0.2r1 manual page 107: Teflon coated lead screws should not be lubricated. Add note for this?
Kagee updated
8 months ago
-
![Mis-labeled BHSC pg 70](https://user-images.githubusercontent.com/7052158/226932289-0e6b0f5f-adfd-4fb9-8ff9-01730405adf9.jpg)
-
page 214 says prior to tightening **don** the fasteners. not DOWN the fasteners. small typo