-
Hi,
I'm using your breakout board as both a cnc controller and sometimes switch to laser mode for etching.
The etching itself works fine, but i'm having issues with the laser constantly enabled or…
-
download https://git-scm.com/download/gui/windows :)
git clone --recursive https://github.com/rusefi/proteus-mitsubishi76-adapter/
-
Given some issues with burning up the bridges, a temperature probe on each one, even an external probe stuck in the heatsink might be helpful. The Firmware could pause or slow down if in an over temp…
-
Hi,
I appreciate your projects while I'm looking at LS1024B data etc. Evaluating whether to use modbus or a python library.
One observation, your code says the 'rated data' is for the 'battery'…
-
Buenas, queriamos saber si este modulo para controlar el motor paso a paso esta bien... https://articulo.mercadolibre.com.ar/MLA-728430892-modulo-a4988-driver-pololu-3d-ramps-cnc-arduino-cdisipador-_J…
-
I think i have read the whole readme and haven't found a link to a connection diagram. I'd like to try this out (on a friend's car :)), but where doi i connect to the mmi? The interface between the ma…
-
-
I opened up my Master Pro controller today and saw that I have an empty 3-pin PWM socket. If I supply GRBLSPD with 5.5v and connect this up like the instructions layout, will it work?
-
5,12V LEDパネルを繋げている状態で48Vをブレーカーから投入したところ火花が散った
その直前にLEDパネルは一時動作したものの7セグメントLEDが異常な動作をしていた 1桁目のみが少し明るくつきそれ以外は消えていた
-
Hello JohnyMielony,
I stumbled upon your project and was keen on building a PCB that contained an ESP32-WROOM and a buck converter to power it. However, I'm not able to figure out the pinouts espec…