-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
I am using Marlin 2 for my MKS Robin Nano 3.1 and when I try to compile, I am getting this er…
-
Now that Input Shaper and ADXL support has been given heavy attention for the past 6 months or so, it seems like it wouldn't be too difficult to mount the accelerometer to a toolhead and use it for Z …
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
With the new style TFT panel after the printer is reset, you cannot print a file from the SD …
-
Hoping to get some clarification on the pin swapping if following the below guide. Swapping pin 2 to pin 3 does not do what I expected. Using the X Stop header added to the board per the Mega P docume…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
It might be just mine configuration but when mesh is calculated, Z Offset set and `G28 …
-
after g29 in pronterface on a perfectly leveled bed I get:
SENDING:G29
Bed x: 30.00 y: 70.00 z: 14.07
Bed x: 180.00 y: 70.00 z: 18.14
Bed x: 180.00 y: 200.00 z: 21.10
Bed x: 30.00 y: 200.00 z: 24.11
…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Auto bed leveling doesn't work. Using the M501 command to reveal its status always resu…
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
If I set parameter EXTRUDER_AUTO_FAN_SPEED to value not equal 255 my extruder fan not working…
-
### Bug Description
Printer start print after ABL (Auto bed leveling) but everything super slow like stutter especially on curves and LCD hangs up on main menu and can't do anything. Some after tim…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
M423 command isn't recognized when enabled. Sending M423 results in:
```
Send: M423
Recv: …