-
I brought a new SKR2 rev B with 5x tmc2226.
I connected the board directly via USB and configured, installed new firmware, etc... After that, I replaced my old board with this SRK2 but the board refu…
-
/status while printing normally responds with
`ok T:37.60 /140.00 B:24.73 /60.00 @:127 B@:12`
`,,SD printing byte 1123/6282205`
After a couple of requests by the webUI it starts responding diff…
-
hello thank you very much for this firmware is very good work !
can you tell me where is the config file for nextion screen ? i wand to add some feature
i dont see any nextion file on your firmwar…
-
Finally got my SKR Mini E3 V2 installed after a few months of saving up for a BTT TFT35 (wanted to do the upgrade all at once) so the official BigTreeTech Store I purchased this from won't help me bec…
-
[I](url
[Configuration.txt](https://github.com/bigtreetech/BIGTREETECH-SKR-V1.3/files/5579359/Configuration.txt)
[Configuration_adv.txt](https://github.com/bigtreetech/BIGTREETECH-SKR-V1.3/files/5…
-
I got stuck trying to add a BLtouch & NeoPixel setup to my Ender 3 with the SKR v2 mainboard.
The works fine with the BTT pre-configured firmware (firmware-bltouch.bin).
I tried to add the BLtou…
-
I have 11 buffers open in vim:
`:ls`
> 1 "gemlist.txt" line 1
> 2 "loremEng.txt" line 0
> 3 a "lorem.txt" line 0
> 4 "osko_…
-
Is it just me or is this back-to-top on top of pagination, all centered disturbing?
-
I purchased this skr2 board to replace my skr 1.4 turbo. I am now on my second board as the first one failed. The replacement board has just failed during a print. The print stopped and ALL LOW is sho…
-
I would like to tree like the image below, but my issue is connecting to the root tree (yellow color) from the left to it, but only 1 node success. What essential if the graph allows adding from many …