-
Hey team,
With the mass proliferation of cheap CC3D boards from a multitude of manufacturers, it'd be great to move away from cleanflight's Naze-centric past and be able to fully support flashing the…
fennb updated
7 years ago
-
The AK8975 Mag not detected during startup, the i2c ack fails.
```
ack = i2cRead(AK8975_MAG_I2C_ADDRESS, AK8975_MAG_REG_WHO_AM_I, 1, &sig);
```
Same hardware works fine with Cleanflight v1.14.…
hydra updated
7 years ago
-
Because as it is now, it is not safe. Theoretically, motors could be commanded to 100% while/before reversing because of unrestricted PID activity. Numerous users in Boris' blog on rcg reported proble…
-
I flashed "iNav 1.0 release" to my FLIP32 10DOF board today, then tried to set up with CF Configurator 1.2.0, just as I did before with older FW versions on this FC before:
CONFIGURATION:
- Softseria…
-
Hi,
I am using a CC3D board. I was using with no problem version 1.8.1 and wanted to upgrade to 1.9.0. It wont work directly from Cleanflight configurator. The connection is lost as soon as I click o…
-
Do we really need to use backup registers in isMPUSoftReset function [https://github.com/cleanflight/cleanflight/blob/master/src/main/drivers/system_stm32f10x.c#L64]?
Following code is faster, cleane…
-
See:
https://github.com/cleanflight/cleanflight/blob/master/src/main/config/config.c#L492
This may be the desired behaviour, I raised this issue in case it is an oversight.
Also note looptime is se…
-
Set:
- Transmitter FlySky FS-I6;
- Receiver FS-A8S;
- F3 V4 AIO flight controller;
I have flashed BetaFlight 3.1.6 (SPRACINGF3, default parameters), configured receiver via I-BUS protocol.
Steps …
-
Tricopter mixer logic doesn't support servo reversing.
-