-
Hi everyone,
i have a problem. I got a thermostat which publish in topic RED an "1" if it's heating. But when the target temperature is reached it publishes an "0" in RED and an "1" in "GRN".
I've "…
-
Occasionally we need the heating on components in a blanket.
Ideally there would be a detailed 3d model with all the blanket components separately defined as cell volumes.
As an early stage is i…
-
Hi,
Since Neptune 3 was advertised to be able to print TPU (quote from elegoo website: Filament compatibility: PLA, ABS, TPU, PETG, Wood, Marble, etc ) would it be possible to add that option to t…
-
if headonly = true, maybe i want to have the following:
off - boiler is off permanently
on - boiler is allways on
auto - based on temperature threshold if currTemp < targetTemp - start heating, i…
-
For verify_heater / verify_extruder, whats the reason to change so far from Klipper defaults?
-
In the sankey.coffee there is a link from primary nuclear demand to the district heating network, `nuclear_to_central_heat_prod_in_sankey`. The only way for there to be primary demand of nuclear on th…
-
Dear,
I have a setup with two zones, floorheating and radiotors (VR70 installed). After adding two VR50 valves, one per room, both zones disappeared and I only have two rooms. While installing the …
job66 updated
9 months ago
-
### Describe the bug.
Reference discussion with @bouwew at tweakers: https://gathering.tweakers.net/forum/list_message/80294530#80294530
I’m using the Plugwise core integration
History:
In Plu…
-
Issue overview
--------------
The central heat pump chiller heater during heating mode (mode 2) always have a part-load ratio of 1. (**Chiller Heater Part Load Ratio Unit 1**).
As a result, the …
-
I would like to be able to see how much power is used by a print. That's all.