-
I've been using the example code provided in the form of
```
conn = new KnxConnectionTunneling(remoteIp, 3671, localIp, 3672);
// create event handlers
conn.KnxConnectedDelegate += Connected;
con…
-
I am trying to connect knxd `0.14.25` to MDT KNX IP Interface (SCN-IP000.02) however it fails with `Connect failed with error 29` which is presented in wireshark as `E_TUNNELING_LAYER`
Below I pos…
-
Hey, I got a problem :-)
I use xknx with Hass and it is filling up my hass logs with the following error message:
```
...
During handling of the above exception, another exception occurred…
-
Could it be possible to add a new manual switch model type:
Type: Switch/Dimmer/Blinds (with percentage)
Model: KNX
ID splitted into 3 groups:
Group1: values 0..31
Group2: values 0..7
Group3: va…
-
### BUG DESCRIPTION
I started to implement a Fingerprint Sensor which communicates via uart 57600baud. In Tasmota I selected SW serial on pin 4,5.
The Adafruit Fingerprint lib sends a ccommand to th…
-
Hi!
After some time it seems that the CCU2 module stops working for some reason:
```
02/27/18 22:28:49.200 Module CCU2: MYCCU2: Could not connect to HomeMatic Wired port. Assuming HomeMatic Wir…
-
**IMPORTANT NOTICE**
If you do not complete the template below it is likely that your issue will not be addressed. When providing information about your issue please be as extensive as possible so th…
-
Hello everyone,
i am very new to KNX. An electrician did the installation and left me alone with the control part. :-/
Anyways, i managed to install the knxtoll and using `knxtool groupswrite ip:127…
-
**IMPORTANT NOTICE**
If you do not complete the template below it is likely that your issue will not be addressed. When providing information about your issue please be as extensive as possible so th…
-
**Home Assistant release with the issue:**
0.70.1
**Last working Home Assistant release (if known):**
**Operating environment (Hass.io/Docker/Windows/etc.):**
Debian 9.4 running in P…
ajuch updated
5 years ago