-
Hello!
Thank you so much for all the hard work that has gone into your firmware, testing and documentation. I read that your goal is "_Make translational drift accessible to more combat robot build…
-
来源:由于现在电热执行器接线复杂，虽然每个器件的成本低、但系统工程的成本回居高不下。
我们计划设计一个电热执行器系统，开关输出控制直接由执行器自身负责，执行器采用串接或总线的方式获取系统逻辑。
温控器采用RF的方式传输控制逻辑。
设计一个BOX用于接收RF信号，桥接执行器的控制信号，BOX和执行器之间仅采用一根两芯或三芯线连接。
-
My datasheet has a requirement to alternate the supply voltage from 1.4V to 5V and obtain the reading during the 5V part of the cycle. This code is based on constant 5V ?
-
logging that includes dthe config for the mqttbroker includes the password
`2024-10-21 10:01:17,326:INFO:runner:main@147: config: {'device': {'name': 'Daly BMS', 'model': '250A16S48V', 'manufacture…
-
Good day,
We are a startup and located in Calgary, Canada. I have came to your profile here because I was looking for a developer (for lack of better term) who might be interested in working with t…
-
Hi,
thanks for sharing your project and for the explanation write-up.
Your design uses 2 MCU pins to drive one TIC (tested IC) pin. I was wondering whether this could be simplified and only one MC…
-
Hi,
EDIT: I could be completely wrong, but is it possible that the schematic is not correct? If I'm using an arduino for the I/O and PRGRM, shouldn't R4 and R1 be pulling up to VCC of the Arduino …
-
Hello,
According to a tutorial - https://youtu.be/LxQWCBE6lLk?t=441 - the SKR-E3-Turbo should have FAN1 header automatic on/off feature based on hotend temperature.
I have defined the extruder f…
-
Behavior:
sometimes it feels the robot is not mowing anything.
Test:
I made several tests where I enable/disable mowing and I change the direction
1. (normal) rosservice call mower_service/mow_e…
-
TMC2130 support for Marlin 2.0 bugsfix has been successfully compiled to run with ESP32. A native ESP32 pin needs to be used for the CS pin, for example, GPIO21 (SDA) or GPIO22 (SCL).
TMC2208 and T…