-
-
Dear Michel, Your work is outstanding and flawless !
I am building a locator set and have some basic questions:
* a BMP uses GPIOs and the Display other ones. They have to be different I read. Fine…
-
Hi
I'm using mbed studio and when trying to debug on a stm32l4r5zitx with a STLink.
I'm getting the following log when trying to debug:
```
Selected port 50000 for debugging
0000297:INFO:…
-
### Board
ESP32 38 pines NODE MCU
### Device Description
I'm developing a project of telemetry using esp-32. I put the codes with the libraries and when i pressed the "ESP-IDF: Build `Project" loo…
-
CheckPoint Safe@Office 1000n:
Quite similar just with slower 300MHz CPU and SFP connector but without WLAN. Discovered the same internal serial tty config as you did this morning (j14 jumper short,…
-
**Describe the Bug**
When using RNodeConf to disable Bluetooth, the configuration is not set. The board still responds to Bluetooth.
**To Reproduce**
Run `rnodeconf (port) -B` and attempt to atta…
-
### Category
Other
### Hardware
Heltec V3
### Firmware Version
2.3.6.7a3570a Alpha
### Description
I have a Heltec V3 with a cardKB and a BME680 (Temperature+Pressure+Humidity+Gas Sensor). When…
-
In Eclipse debug launch configurations, I'd like to use a variable like ${project_name} in the Project: field on the Main tab so I can reuse .launch files across projects without modification. Curre…
-
### PROBLEM DESCRIPTION
_A clear and concise description of what the problem is._
I have 5 ESP32 devices wired to Mitsubishi AC, controlling some EQ3 TRVs and reading temperature and humidity from…
-
It would be nice if arduino would create a *project* file in the sketch directory so that I don't need to manually change board setup each time I switch projects.