-
Alright, I touched on this in my last post in here, but I'm going to make it an actual issue now that it's happened twice during glaze firings to see what is going on or what I may be doing wrong.
…
-
I cloned RC6 and then used a diff tool to carefully copy over only the relevant configs from my RC3 Configuration.h to the RC6 Configuration.h and uploaded to the arduino board on the printer (using A…
-
Cannot get the Buzzer to chime when sending M300 S1000 P1000.
The buzzer works with the LCD button press, but will not work with M300.
Any ideas?
-
Symptoms:
1. If I start bed preheating without turning the hotend on, after some time the machine reloads. Was the preheating started from the menu or from the file does not matter.
2. If I start th…
sofos updated
2 years ago
-
Recently updated HA Core to 2022.3.8 and just noticed multi-zone control problem from the UI. Not sure the update caused the issue. When attempting to increase the set point from the current setting, …
-
### The problem
After moving from "ISY994i" to "ISY994i on Polisy" I noticed an issue:
The HA ISY integration can be installed, configured, and works fine. When Home Assistant is restarted, the inte…
-
Using the latest build and when I issue a G28 command to home all axis the autobed leveller servo tries to swing down but crashes into the edge of my bed and will not trigger. The Z axis is still tryi…
-
Hey thanks for this great Work.
With the Rc3 i have no Z Values in display.
It Shows Only Z:---.--
Repetier Host Shows the Correct Values.
I Use ramps 1.4 with the RC3 Release
My Config
``` cpp…
-
We use Zeroconf discovery to help the discovery of our integrations. When discovered via Zeroconf, we can launch the config flow of the integration and help the user set it up.
To get this working…
-
Hallo wiserHAP people,
It's perhaps an edge case but I live mostly outside the UK/Ireland and I am seeking to remotely smart manage the heating in an old family place in Ireland.
I had been thinki…