-
Hey guys, lately on my SKR V1.1 Pro board, I've been getting this strange `coil short circuit` error with my TMC2208 drivers (which are on my Extruder and Z axis). I've gone and checked the wiring and…
-
i got drive TB6560 4axis blue board and arduino uno board
i connect the drive with arduino and start to test X axi
> > > this is the data sheet for the DB25 Connector
> > > http://postimg.org/image…
-
```
When the X or Y Axis is moved, the stepper motor for Z is not 'enabled' thus
it tends to drift when the X and or Y axis move.
All is OK for the X and Y Axis, when either one moves, the other is l…
-
*Moved from https://github.com/arduino/Arduino/issues/3300 by @cxrodgers*
I was having an intermittent issue where my arduino would occasionally lock up while stepping a stepper. It turned out that…
-
I'm sorry for my bad title but I couldn't think of a better one.
I am using StepperOnline DM860T drivers connected to a GRBL controller.
Previously I used cheap TB6600 drivers which worked instant…
-
In many cases the opening of the gripper fails possibly due to a certain mechanical resistance in moving the disk against the force applied by the fingers towards it.
A possible solution might be t…
-
Hello, I think that bcnc has natural talent for controlling quilting embroidery machine!
Driller feature of bcnc looks so simmiliar to professional quilting or embroidery machines/software where nee…
-
```
Hi,
thanks for pyduino. I'm using it successfully on Linux with my Arduino
(Duemillanuove) and extended it to support stepper motors (by adding some extra
sysex commands to the firmata protocol)…
-
Hi,
Was wondering if you made any progress with changing the wash direction mid-term. Maybe it would be easier to change the direction every few minutes, using a sort of flip-flop logic?
-
Hello,
I've found no way to get this board working with dual Z driver and dual Z endstop.
The second Z driver (Z2) was recognized, but the endstop resource never be used.
My actual configuration …