-
I know that i'am not at all in the right forum for this kind of stuff
_(i also dont know where the right place for this could be)_
but maybe someone can help me or it might could actually be a bug…
-
The G33 calibration converge tries to reach strange positions especially around Gana tower. The height is measured properly by G33 P1 command but in case of delta tower, endstop and radius calibrati…
-
Just noticed that i’m getting odd intermittent behaviours when homing (g28) after initial home.
Replicated with the following sequence:
```
Power on machine or following a reset
G28
G27
G28…
-
### Description
I have delta and recently upgraded to a 32bit board (SKR 1.3) and also to TMC2130 (and I have 256 micro-stepping). No matter what, when I run my usual printer calibration routin…
-
Hello,
I have home made 3D printer, Ramps board with latest 2.0.4.4 Marlin release and Bigtreetech TMC2209 drivers on X and Y axis. I am able to move axis, but UART connection don't work. "TMC connec…
-
https://gist.github.com/drj-io/56db4be7e002e763ff5e0c2a5e256f59
I'm using Big Easy Drivers (sparkfun). I'm able to run the above code with steppers 1-4 or 3-5... any combo of 4.
If I engage 5 or 6, …
-
Marlin 2.0.1 - Ender 3 SKR E3 mini V1.2 - very loud work of the z axis motor , other engines silent
-
Hello
I am trying to update to the last version, i have tried with both versions 1.1.9 and 2.0, and my probe does not stop at homing.
Z_min is below bed level and I use the z_probe as Z_homing.
…
-
Hello.
I am having an issue with marlin running on a smoothieboard not outputting E steps.
I am running TMC2130 drivers, all are ok according to M122.
Dual Z axis so extruder is configured for M5…
-
### Description
Compiling Marlin 2 bugfix for a ANET A4 delta (Melzi board with atmega 128k) and 20x4 LCD controller.
Activated babystepping with doubleclick feature during print as well as:…