-
support ?
-
I'm using Arduino IDE 1.8.15.
I use Arduino bootloader shield from DIYMORE. I uploaded a lot of coding in Atmega8 using this shield. But Today, I got a LED CHASER code from a YouTube channel. I trie…
-
**Do you want to request a *feature* or report a *bug*?** bug
**What is the actual behavior?** Using an ATMega328P-PU (28 pin), when adding a Read ADC command to ladder code and I go to add an anal…
-
Hi,
I'm trying to get a boot-loader going on a little ATMega8L I had laying around. (The ATMega8L is basically the same as the ATMega8, but limited to 8MHz and an operating voltage range of 2.7-5.…
-
Objective: Remotely upload a new sketch onto an arduino via esp-link / El-Client / avrdude where it is physically difficult to be at the arduino device (ie: hanging off a weather station tower, laptop…
-
Currently i use Attiny85 with micronucleus and in arduino IDE i have to add "digispark" board repository:
`http://digistump.com/package_digistump_index.json`. But they only support ATTiny85 and ATTin…
-
Using ATMega8 MCU should how to write
-
avrdude: ERROR: address 0x1e010 out of range at line 2 of bootjack.hex
Minor change in done is
static inline bool app_present(void)
{
//const __flash volatile uint16_t *start = CONFIG_APP_…
-
_Original author: neve...@freemail.hu (July 16, 2010 15:30:06)_
Hi!
With Processing (version 1.2.1) I wanted to control a LED connected to an ATmega8 based circuit. I have used the following Bluetoo…
-
Library doesnt work with atmega8 micicore bootloader 1 Mhz internal clock? Any clue on why this could be?
Since library would be made over existing SPI drivers, i assume if this is working with atmeg…