-
I was looking at the thermostat information coming back from the ISY and had a question or two about it.
First, it is pretty important to know if the compressor in a heat pump or A/C unit is runn…
-
### The problem
When my Residio T9 thermostat is in cool mode, integration uses the maximum heat setpoint as the max setpoint limit instead of the maximum cool setpoint. As my cooling range is set t…
-
(Note: It's not a "hot water heater". No one needs to heat hot water.)
The water heater hasn't been heating as well as it used to. The colder weather could have a slight effect on performance beca…
-
Situation:
High Lux Available && Batteries are full so MPPT will not make more power due to smart overcharge protection.
So, use SolarPi to trigger a relay to run a heating element with an insula…
-
After gerenrating a gcode file with Slic3r (Temperature of Extruder set to 228° and Bed to 90°) I checked the file and found M104 S228 command lines in the gcode file.
Transcoding works fine, uploadi…
-
Hi,
Is it possible to implement a dp in order to show in HomeKit if the Heater is Cooling/Heating/Off?
Right now, whichever temperature is set, HomeKit shows it's always heating even though, for…
-
The main supply heating coils for the air loops in the original DOE prototype models use a default 55F inlet/104F outlet air temperature. The openstudio-standards models assume a 45F inlet/55F outlet…
-
I would like the possibility to see state of device.. example, I use fibaro binary sensor, with window magnets, here, I would be nice to chose this input, and close a icon, ore upload one, like the to…
BPC83 updated
6 years ago
-
@MartLubben found this issue
There is no data available for the cooling technologies shares for European countries, so also not for the EU27 dataset. We now assumed the same dummy values for all th…
-
Hi Martin,
i use your plugin to control my heating convector in living room. When thermostat is set to Auto mode (auto heating to 23 degrees) and i restart homebridge for some reason (configuring som…