-
Since some beta version, the teleinfo information are no more automaticaly updated, and I have to set a delay on the device in order to restart it every minutes in order to get the information again.
…
-
```
...
Recv: T:185.0 E:0 W:?
Recv: T:186.3 E:0 W:?
Recv: T:186.7 E:0 W:?
Recv: T:187.5 E:0 W:?
Recv: T:188.6 E:0 W:?
Recv: Error:Heating failed, system stopped! Heater_ID: 0
Changing monitoring state…
-
My first GitHub so I apologize if this is not the proper method.
I would like to see the ability to add more sensors -- like CO sensor (analog or digital) and possibly Pulseox (analog likely).
Stat…
-
I have some collapsible menus (details/summary) inside one of the tabs. When I switch the tabs to Small or XS, the open/close state of those menus gets reversed when I flip between tabs "Calcul des n…
-
I have Evohome in two locations, so per expected behaviour your very cool piece of software politely tells me there is more than one location and stops!
Do you have any recommendations how I can han…
-
Hi,
I really appreciate the python library for the SHT75 sensor. However the temperature results I'm getting are routinely a little high and I cant yet figure out why. At the moment all I have as ref…
-
As #127 is a little overloaded and goes beyond the technical, I thought to open up this issue to gather implementation details and coordinate efforts for this.
Support for WebSockets is already prese…
-
```
With the (upcoming) release of 1.3.0, it's time to think about and work on the
next version of the Z-Wave binding. We like this as much to be a collaborative
effort as the previous version was.
…
-
I've submitted a ticket with [3dprintingsystems.freshdesk.com], and I'm waiting to here back, but the red UP printer will get partway though a job and stop. Monitoring while it happens, the UP program…
-
Octoprint is running, I'm logged in and I click connect to connect to printer and I get the following message.
Changing monitoring state from 'Offline' to 'Detecting serial port'
Connecting to: COM4
…