-
If it is turned on then a workout automatically starts after we select the KayakPro. After the workout is stopped the spin down fails, the weight input can already fail, then sometimes the device disc…
-
I've taken some rough measurements of how long `emokit_read_data_timeout` and `hemokit-dump`'s main loop take per iteration.
For this I modified:
``` c
int emokit_read_data_timeout(struct emokit_dev…
-
In addition to #16 please implement a special data sending mode -- **when a change occurs**.
For example, a device is resting on a shelf and it will not report gyro data even for hours or for the w…
-
What are main requirements for this app?
I've done some research and I think that for now we should do:
- Display voltages for each cells
- Display total voltage for the battery
- Support 2 to 6 cells…
-
We should be able to have a plan that for different zoom levels automatically finds the pixels per micron
-
### What happened?
in the descriptive note, the units given for this sensor are:
- VOC: ppm
- formaldehyd: mg/m3
However, in the Tuya application, these two data appear:
- VOC: with a factor /1…
-
I'm trying to use the serial port but no response from the inverter:
Whit the same serial adapter and windows PC i'm able to connect to the inverter using the WatchPower tool.
```
pi@solarpi:~/…
-
### The problem
I do have a Shell Plus 2PM, which is flashed with ESPHOME.
I wanted to use a current_based cover here. When I first flashed i did not set the `start_sensing_delay` parameter.
As it…
-
Hello,
I have a Vitocal 200S which uses a different command set (see https://github.com/openv/openv/wiki/Adressen#adressen-um-werte-abzufragen-oder-zu-setzen), which I already used successfully for…
RoP09 updated
10 months ago
-
I want to use a logic analyzer to measure the relevant timing parameters:
1. The time to initialize the DS18B20 and monitor the online information
2. The time to wait for the DS18B20 to release the …