-
Hi all,
I installed two TMC2208 drivers (Z and Extruder only) on my RAMPS 1.4 board. I followed some very good step by step tutorial/s:
- https://youtu.be/lNS6_cXNN_o
- http://www.shiryou.es/impr…
-
Hi,
Just upgraded a Melzi board to RAMPS 1.4 board with latest Marlin release. All motors are moving only in one direction. This was my first time configuring Configuration.h, so I'm pretty sure th…
-
quick Q:
are there any reason for tmc2208 not being in the pins file yet?
i ASSUME that marlin does not support the ethernet addon and was going to use those pins for the 2208's, but are there a…
-
Hi there.
I see that in marlin's (config_adv),i can set my params for my stepstick.
I would like set irun,ihold,toff,delay,autograd,hend,hstrt,tbl
I don't know what parameters are supported,and the…
-
I have configured Marlin 2.0 bugfix for a SKR v1.4 Turbo with TMC 2208 v3.0 drivers. I am running in the parts of a cr-10s 500. I have had success running both z motors with the single tmc stepper an…
-
### Bug Description
So, I'm trying to build 2.0.x using the Makefile, and I keep getting a link error with "undefined reference", as follow:
```
CXX src/libs/stopwatch.cpp
CXX src/libs/…
-
### Bug Description
The pin on my original bltouch 3.1 isnt deploying when trying to abl from the print menu. But the pin does deploy and retract in an auto test when powering on as well as sending…
-
[configs.zip](https://github.com/MarlinFirmware/Marlin/files/5287022/configs.zip)
can't get it to auto home, the z will not go up when I enable the following in marlin bugfix 2.0
Z_MIN_PROBE_USE…
-
@benlye Congratulations for your work.
I would like you to consider adding support for OpenBLT bootloader. It is an OpenSource bootloader suitable for the use with many microcontrollers, and, therefo…
-
### Bug Description
I got a problem with Anet a8 plus, My capacitieve sensor goes outside my bed to measure, when I try to auto level.
I use marlin 2.0 and search everywhere for the solution. …