-
```
It would be easier to create third party boards with a bit more help from the
IDE, if it were to provide a #define for the board and mcu_family. Further, the
xmega fuse bits are much different t…
-
```
A fix is to check for the esc char before setting in_bootloader
#ifdef USE_ENTER_UART
// Check for received character
#ifdef __AVR_XMEGA__
if (…
-
```
It would be easier to create third party boards with a bit more help from the
IDE, if it were to provide a #define for the board and mcu_family. Further, the
xmega fuse bits are much different t…
-
```
I need avrdude 5.8. I'm porting arduino to the xmega. 5.8 knows about the
xmega, the hacked 5.4-arduino does not.
Avrdude 5.8 burns bootloaders just fine. But, when trying upload a sketch,
it rep…
-
```
It would be easier to create third party boards with a bit more help from the
IDE, if it were to provide a #define for the board and mcu_family. Further, the
xmega fuse bits are much different t…
-
```
It would be easier to create third party boards with a bit more help from the
IDE, if it were to provide a #define for the board and mcu_family. Further, the
xmega fuse bits are much different t…
-
```
It would be easier to create third party boards with a bit more help from the
IDE, if it were to provide a #define for the board and mcu_family. Further, the
xmega fuse bits are much different t…
-
i have made a ChameleonMini, successfully installed firmware, and have access to console configuration.
When trying to emulate a card, I found cannot scan it with a reader (phone or ACR121). Maybe it…
-
Here's an excerpt on an off-line discussion about where Grbl is going and what's next:
**chamnit** : This is something I've been thinking about often recently. Is Grbl done? Or have we pushed it abou…
-
```
It would be easier to create third party boards with a bit more help from the
IDE, if it were to provide a #define for the board and mcu_family. Further, the
xmega fuse bits are much different t…