-
Hello, I am not sure if this is the right way to ask for this:
### Description
Please add an Ender-3 Pro Configuration Example for newbies like me. The Ender-3 Config is not the same and differe…
-
### Description
Commit b9418439b94d6d7ba1b700d16c78888e458d4102
During homing, the Z move "bumps" when my sensor triggers, like normal, but the speed of the second/bump move is definitely the sa…
-
Hi all, I am getting a problem running G29 X5 Y5 L25 R65 F110 B160. The procedure does not finish and seems to try and rehome the Z outside of the build plate half way through, then throws a comms err…
-
I am trying to put the latest Bugfix version on one of my Anet 1.0 boards. I get the code below. Any ideas? Also, seems the Anet 1.0 board doesnt show up on a regular Arduino version, you have to use …
-
### Bug Description
This is Marlin bugfix-2.0.x, commit 0ebd2f44, running on a newly-built Hypercube with SKR v1.4 controller (which has TMC2208's on X, Y, and Z, and A4988 on E) and RepRapDiscount…
-
### Description
Enabling Linear Advance while using Trinamic TMC2208 stepper drivers on the extruders almost immediately causes the extruder to stop extruding - any K factor larger than 0 has some …
-
The G33 calibration converge tries to reach strange positions especially around Gana tower. The height is measured properly by G33 P1 command but in case of delta tower, endstop and radius calibrati…
-
I know that i'am not at all in the right forum for this kind of stuff
_(i also dont know where the right place for this could be)_
but maybe someone can help me or it might could actually be a bug…
-
Just noticed that i’m getting odd intermittent behaviours when homing (g28) after initial home.
Replicated with the following sequence:
```
Power on machine or following a reset
G28
G27
G28…
-
### Description
I have delta and recently upgraded to a 32bit board (SKR 1.3) and also to TMC2130 (and I have 256 micro-stepping). No matter what, when I run my usual printer calibration routin…