-
The new vacuum former has failed its PAT test.
The insulation resistance is too low, at 0.24Mohms.
-
I've tried the ap_sta_config2.sh on a Raspberry Pi 4 with Raspberry Pi OS Bullseye.
It doesn't work out of the box, but after a couple of tweaks, it's able to configure the device and after reboot,…
-
Migrated from [rt.perl.org#2783](https://rt-archive.perl.org/perl5/Ticket/Display.html?id=2783) (status was 'rejected')
Searchable as RT2783$
p5pRT updated
9 months ago
-
Python not good, use one of these:
A
[A.NET (A#/A sharp)](https://en.wikipedia.org/wiki/A_Sharp_(.NET))
[A-0 System](https://en.wikipedia.org/wiki/A-0_System)
[A+ (A plus)](https:/…
-
makeYbus fails when using pypower test cases due to one-indexing issues. For instance, for:
`import pypower.api as pp
ppc = pp.case14()
baseMVA, bus, branch = ppc['baseMVA'], ppc['bus'], ppc['bra…
-
pp.runpp(net)
_powerflow(net, **kwargs)
_powerflow
ppc, ppci = _pd2ppc(net)
_check_for_reference_bus(ppc)
n.py", line 322, in _check_for_reference_bus
UserWarning: No refere…
-
Hi,
**I encountered a weird issue. The DC power flow can converge, but the DC OPF cannot, even after all branches' rate_A have been set as 0 (i.e no limit). How could this happen? (I have checked t…
-
Hi:
I am using asap-7 behavior model provided inside hammer. I was wondering whether both ports of SRAM2RW* instance will be used to write **and** read, because I want to substitute asap7-sram wi…
-
Experimental branch pushed, discuss testing and issues below
-
I have a little bit of sun today and have been looking at the dashboard.
I've noticed that the L1L2L3 Forward Watt and Reverse Watt are exclusive as if i had a meter working after the summation pri…