-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
Despite starting with G28 & G29 in my G-code file, and the firmware & BLTouch doing a proper …
-
### Bug Description
I've followed instructions on how to compile Marlin firmware : https://marlinfw.org/docs/basics/install.html
### Steps to Reproduce
Download fresh copy of the 1.4.3 source…
-
I am trying to use the FILAMENT_RUNOUT_SENSOR option for printer to pause when there is no filament however, it does not seam to work.
I use RC6 latest DEV with RAMPS EEB config and filament sensor …
-
Filament Runout Sensor needs implemented.
Plugged into XMIN / Pin PB6 (See [OHAI instructions](https://ohai.lulzbot.com/project/lulzbot-taz-sidekick-runout-sensor-installation/accessories/))
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
Print pauses randomly, usually in big prints over 5hrs. Triggering the V86 echo message similar to w…
-
I can't speak english. I used google translate.
marlin 1.1.0 rc3....
Configuration.h
``` cpp
//===========================================================================
//=========================…
-
Tried to enable the filament runout sensor on my homebrew 3D printer (Marlin 1.1.0-RC7, ATMega2560, Ramps 1.4, RepRapDiscount Full Graphic Smart LCD-Controller) but the firmware simply ignored my sett…
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
When settin in Marlin 2.0.9.3 and earlier MKS LVL + ADVANCED_PAUSE_FEATURE + FILAMENT_RUNOUT…
-
Here are a couple of things that just not seem right with the filament runout sensor:
- when no FILRUNOUT_PIN is assigned you get no error
- const bool FIL_RUNOUT_INVERTING = true; and should be fals…
-
### Description of the bug
When I tried to load the eeprom for the snapmaker 2.0 a350, it didn't pull in any information. I can only see "Firmware Info"
If i run M503, it pulls back all the infor…