-
Yesterday I installed repetier on my DaVinci 2.0A (jumper J37, `#define DAVINCI 3` and `#define MODEL 1`).
I did a manual bed calibration and it seems to work fine.
But when I tried to upload the Ard…
-
One feature I've been thinking of implementing in my own half-functional G-code generator (https://github.com/bgamari/GGen) is plotting of monochrome SVG images (and perhaps eventually of raster image…
-
I have been having problems getting rid of blobs when using LinuxCNC to drive my MendelMax. I have finally traced this back to the use of G0 moves combining retract with travel when I select the "Mac…
-
I noticed that the extruder seems to stop and then retract, on a bowden system (i.e. Huxley's) the tube has enough tension to allow quite a lot of plastic to come out. Would it be possible to have an …
-
Add to gcode generation...
M117 display message on LCD
M226 gcode initiated pause
-
commit d5537e7797e24e34560f419d7ccb132b2cefcd9 leaves support material completely unresponsive.
-
Thanks to slic3r and spp, I was able to find the maximum reasonable extrusion rate my ultimaker can do at a given temperature. It is discussed here:
https://groups.google.com/forum/?fromgroups#!topic/…
-
I'm running from dev at commit c4bfe64fb (2014-04-19)
I noticed that the default perimeter was changed to 200% ( commit b9793b3 ( 2014-01-03 00:34:30 +0100 1223) this->first_layer_extrusion_width.v…
-
(freegl works! Yeah!)
1) stl filename defaults to something.gcode, which will at some point get someone to overwrite their gcode file. (ok, me. It was me. I wrote over my gcode file stomping an hours…
-
When I import a stl and generate the gcode the gcode results in a negative offset on the x axis.
I am using slic3r 1.2.1 and used the configuration wizard to start over with the settings.
See screens…