-
While some requirements are pinned many are not. This will cause repo code to quickly degrade if its ever put into a non-active mode.
-
I actually wanted to ask how do I `unload` / `detach` a bpf prog.
I had initially loaded and attached a bpf program using
`sudo bpftool prog load inject_error_v2.o /sys/fs/bpf/inject_error_v2 au…
-
### Description
We should ensure that the helm installation instructions also specify the correct version of the chart that corresponds to the currently browsed version of the docs (like we do for `k…
-
-
### Board
All
### Device Description
Any device
### Hardware Configuration
Any configuration
### Version
latest master (checkout manually)
### IDE Name
any IDE
### Operating System
any OS
…
-
Hi! It's me again :)
I've ordered my parts and started soldering, but I'm having trouble connecting the two parts. I have done the following:
- Soldered each RPI2040 and flashed them with their …
-
## Issue template
- Hardware description: ESP32
- RTOS:
- Installation type: arduino ide
- Version or commit hash: humble
#### Steps to reproduce the issue
#### Expected behavior
I …
-
hello owner, why my SD card initialization failed!, i make sure the pin i use is correct
-
Hi,
I can see the in block diagram(DS-012 V6X standard) ADIO(8pin JST GH) 3 bits for bootloader. I couldn't figure out corresponding 3pins used for boot loader in pinout sheet. but i can gues…
-
This function is newly added for RP2350, and the implementation appears inconsistent with the datasheet.
Datasheet says:
> Set the number of pins which are not masked to 0 when read by an
> IN …
arg08 updated
1 month ago