-
Ever notice how your optimal PID values change between full and flat batteries? This is due to the battery voltage drop essentially causing a system gain change - about 20% between full and flat.
He…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
Line 181 states that carry is set. This is irrelevant for r/w mode as **RangeTestIns1** unconditionally re/sets carry. For r/o mode this becomes an issue because the insn _setting_ the carry flag:
``…
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…
-
```
Rather than the standard "steps to repro, expected output, etc.", this bug
report will just "dive in" to details...
Problems occur when using the feature documented in the Propeller GCC Library …
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
Which board (stock / gruvin9x / sky9x) are you using?
stock
What is your open9x FW version?
R1563
What is your open9x EEPROM version?
What steps will reproduce the problem?
When I switched from …
-
This thread brought up an arbitrary limitation that we can resolve.
http://forums.parallax.com/showthread.php/157572-PUB-CON-list-overflow-in-Propeller-Tool-1.3.2?p=1304322&viewfull=1#post1304322
Le…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…