-
Hello, i'm developing an acceletometer sensor network (Arduino) and i'm having problem receiving data on the master node (Raspberry Pi), slaves are identified sensing an ID byte on the message and sen…
-
Hi,
Thanks for your effort to keep this project updated.
My first question: Is this project implementation of WiFi? I mean is it possible to have a IEEE802.11 network with one USRP N210 and some lap…
-
Test signal over radio wave compared to wifi or cellular network
-
Wire the transceiver to the pi and test connection methods and write new scripts.
-
Hardware: QCA9531(host) + efr32mg21 / nrf52840 (rcp); efr32 connect with usb2uart, nrf52840 connect with native usb
Software OS: OpenWRT 17.07.7
Test device version and uart config:
ot-br-…
-
## Environment
- Development Kit:
- Kit version
- Module or chip used: ESP32S2
- IDF version 4.2
- Build System: MicroPython
- Compiler version 8.4.0
- Operating System: Ubuntu (Linux)
-…
-
# Introduction
Our team at the Laboratory for Atmospheric and Space Physics (LASP) at the University of Colorado Boulder (CU) recently completed the integration of the Colorado Ultraviolet Transit …
-
I did a bit of a teardown of the device, but could not find the microcontroller data sheet it uses. How did you work out its communication?
[Btw here is the teardown of the iTag PCB](http://briankhuu…
-
I recently (rather late!) downloaded the most recent RF24 library and updated my radio control project. The transmitter worked perfectly and immediately without any code changes. But when I updated th…
-
### Steps to reproduce
1. Install Gqrx software, 2.14.4 version
1. Use hackRF device (february 2014 PCB version)
1. Update firmware to 2021-03 version
1. Update hackRF driver to 2021-03-1 version
1. U…