-
I managed to move the stepper motors through the commands in the Arduino IDE Serial Monitor. But there are still intermittent small movements of the steppers (tracking?) If I enter the command: TRK0 #…
-
This happens rarely and I have not been able to get it to reproduce reliably.
Early in a session (typically) if a tool (DT or Handibot) runs into a hard stop, FabMo locks up ... as if it may have los…
-
I have S109 drivers based on TB67S109AFTG. They need vcc=5V.
May I set VLOG JP101 to 3-2, (FD_5V) with Due ?
-
I've been observing students have trouble with the soldering for making custom wires. Admittedly this is a pain. Some ways to eliminate this:
1. Use stepper motors [1](https://www.amazon.com/STEP…
-
```
Hi,
thanks for pyduino. I'm using it successfully on Linux with my Arduino
(Duemillanuove) and extended it to support stepper motors (by adding some extra
sysex commands to the firmata protocol)…
-
```
Hi,
thanks for pyduino. I'm using it successfully on Linux with my Arduino
(Duemillanuove) and extended it to support stepper motors (by adding some extra
sysex commands to the firmata protocol)…
-
```
Hi,
thanks for pyduino. I'm using it successfully on Linux with my Arduino
(Duemillanuove) and extended it to support stepper motors (by adding some extra
sysex commands to the firmata protocol)…
-
```
If the stepper doesn't complete a full resolution or goes for long periods of
time between steps or steps over a long period of time, it gets really hot
due to a bug in the stepper code. It leav…
-
Hi Terjeio, I'm trying to use GrblHal on a SKR3-EZ board with 5160 drivers (4 axis). I had some problems with USB communication, but @Dresco helped me and solved it. Now I'm having problems with Trin…
-
Some G2 commands are throwing assertion errors. For example:
```
----- Hardware not detected, using virtual environment -----
----- Use M111 command to enable more detailed debug -----
*********…