-
**What's your question?**Hi, just installed this on my Predator with a 40 element LED Neopixel ring, mounted in the roof of the build area. Looks really cool and initial startup seemed to go fine. I c…
-
**Is your feature request related to a problem? Please describe.**
Problem: People sometimes assume the printer is cooled down just because it has finished a print. This results in "ouch!" more t…
ssl-3 updated
3 years ago
-
Hi, thanks for making this awesome package!
I just did a fresh install on a brand new Raspbian installation and I'm getting the error below. Any ideas?
`pi@raspberrypi:~/led-control $ sudo le…
-
Hello, I recently setup an enclosure with LEDs using the Enclosure Plugin. I decided to add an OctoScreen interface to my enclosure so I didn't have to go to a computer to start/stop prints anymore. A…
-
The following code does not produce desired result on a Raspberry Pi Zero W running Raspbian 9.13:
```
pi@nullpi:~/bin $ sudo python3
Python 3.5.3 (default, Jul 9 2020, 13:00:10)
[GCC 6.3.0 2017…
-
**ESPixelStick Firmware Version**
ESPixelStick_TRAVIS-20201230114122.zip
**Hardware Version**
ESP32 Lolin Dev board wit CD caard
**Binary release or compiled yourself?**
Built myself
**Des…
-
Ok, so following what was going on in #692 . We are thinking about using Ubuntu to make 64bit builds. And also testing to see how using a distro with predictable release cycles works with OctoPi (we m…
-
Hello,
i tested and had success with neopixels on RPI4, on your libs !!
But i changed board for a Jetson NANO, and i can't use your libs anymore !
here is the error :
```
from rpi_ws281x impor…
-
- [x] I confirm that this is an issue rather than a question.
## Bug report
Second LED Stripe on Raspberry 4 GPIO /dev/spidev1.0 not selectable from Webinterface
#### Steps …
-
Is there anyway we can set the base temperature. for example,
my room with my printer is always around 22 degrees,
I have a strip of 20 leds and they always start half way along for progressing the …