-
How to get 24 volt output
-
Hi,
Managed to make a version that use 12v WS2815 leds strip .
Noticed that the Red and Green colors are inverted.
-
Der Roboter kann in der aktuellen Situation keine Figuren aus engen Räumen heben (Beispiel: eine Figure ist von mehreren anderen Figuren umstellt).
-
The kona odometer can be found on PID 22B002 ECU 7C6 ( cluster module ). Hex dump on my kona is -
```
pid 22b002 @ 2019-09-28T00:12:22.593056
CLU 7CE 21 00 00 B6 00 00 00 00 [?=0] [?=0] [?=182] …
-
Hello, i was wondering how would i go about connecting **Relay** to the board in a way that would Turn on at the same time as laser engraver.
In the past i tried connecting standard relay to the t…
-
This is the fuel consumption output to get the dash econometer and the on board computer to show consumption and range correctly.
I believe we will be able to provide this signal but we currently ha…
-
Simulating the ideal diode circuit around Q2 I stumbled across a bit of an issue.
When the input voltage is negative and the ideal diode should be blocking, there is a leakage path through Q1B, R10…
-
We currently have two options- from Adrien:
- Will a small 5V micro-sub battery do the job for 24h (i.e., the maximum duration of deployment)? Secondly, how fast will it be recharged?
- Alternatively,…
-
```
This is what is missing from the Asus Rampage III Extreme x58:
Winbond W83667HG
Temps: NB and SB
Voltages: 12V, 5V, DRAM, ICH Core, ICH PCIE, QPI
On a side note, Voltages are also missing for OH…
-
```
Hi all,
I am building the Arduino quadrotor from scratch. So far, the frame, arduino
board and every necessary stuff has been put in place but the plane still tilts
to the sides when I try to f…