-
Hi,
I have an issue with the WxReceiver sketch, on a Motino R4, with BMP280 sensor and 868mhz rubber aerial.
Not sure if its my config of 3 transmitters (all in UK, so EU band)
Tx1 - Wind / UV…
-
Hi Sebastian,
thanks for your work to put this together.
I am running a hydroponic system in my office growing lettuce based on the Uno Wifi Rev2 with lots of sensors on it. I bought a flowmete…
-
First of all thank you for this fantastic program. It has done wonders for my little 28byj-48 steppers and enabled my project.
I am trying to add support for a new type of printer to Klipper.
I ca…
-
**Have you looked for this feature in other issues and in the docs?**
Yes
**Is your feature request related to a problem? Please describe.**
New original sonoff sensor (v1.0) is different. …
-
So I'm trying to figure this out, I thought the board should output, when using digitalWrite (stm32duino), 5V if the board is 5V powered, and 3.3V if it is 3.3V powered, but I'm getting 3.3V on all th…
Akrai updated
3 years ago
-
re: https://github.com/adafruit/Adafruit-MCP23017-Arduino-Library/tree/master/examples/interrupt
please provide interrupt examples also for Adafruit M0, M4, and Arduino Due (M3) (and possibly als…
-
Hi,
i have some troubles with my WHID and i can't do anything and still don't work. When i plug it into USB port i get:
Sep 13 15:29:50 usb 3-8: new full-speed USB device number 21 using xhci_hc…
-
Hello.
I am using Berd-Air to cool the PLA.
Yesterday, I replaced the air pump motor used with Berd-Air.
The new motor is a PWM-controlled brushless motor called A3650.
The replacement went well…
ghost updated
3 years ago
-
**Edit by Spence** _The version of the Wire1 library referred to here has been pulled from the core for v 1.3.3 and later, since it was unfit for any purpose largely due to this issue. We still really…
-
Hi
I am planing to try and make a Amiga/C64/Atari joystick adapter. I glimsped at some items a about it a long time ago. But It seems you need special kind of atmega chip to do this. (32U4) Which …