-
Hey there! here's the thing: if i choose 8MHz, BOD 2.7, EEPROM ret, LTO disa, !!!BOOTLOADER Yes (UART0)!!!, Programmer: Arduino as ISP, sketch doesn't load due to baudrate = 38400 instead of 19200.
b…
-
There is an issue of incorretly staded flash size on bare AVR parts with 8KB of flash memory, namely:
https://github.com/platformio/platform-atmelavr/blob/develop/boards/ATmega8.json
https://github.…
-
In the description, you write
> ArduinoShrink supports only ATmega8 and ATmegax8 MCUs. Accurate timing for millis() and delay() requires a freqquency that is a power of two such as 1Mz, 8Mhz, or 16…
-
## Bug Report
### Arduino Platform
* [ ] Arduino ATmega328* board (UNO, Nano)
* [ ] Arduino ATmega2560 board (Mega)
* [ ] Arduino ATmega32U4 board (Leonardo)
* [ ] Arduino megaAVR board (NanoEv…
-
## Bug Report
### Arduino Platform
* [ ] Other - please specify: atmega8a barebone
### IDE
* [ ] Arduino IDE
### IR-Protocol
* [ ] Kaseikyo
### Example to reproduce the issue
* [ ] Oth…
-
Hello, guys.
I am trying to find out, how should I programm MiniCore to Atmega8 without hardware programmer.
I found phrase
**_(If you're not planning to use the bootloader (uploading code usi…
-
When trying to compile the code for the first time. I am receiving
the error below.
Interrupt.ino: In function 'void interruptSetup()':
Interrupt:17: error: 'TCCR2A' was not declared in this s…
-
Hi Brian
Just noticed that Eagle showed 3* missing libraries of which 2 were automatically downloaded but it still shows your pepin library as missing.
Regards
Chris
PS: Considering to build you…
-
To reproduce:
- Get a non-arduino-preloaded Atmega168
- Flash any sketch using programmer (e.g., Blink)
- Sketch does not work (for Blink: LED just stays on all the time)
For comparison:
- Flash the …
-
In the examples it's written that callbacks are available for `ItemCommand` and `ItemToggle`, however in the code I see that `ItemInput` can also have a callback and even calls it with `.enter()`, but…