-
My axis seem to be turning in the correct directions to compensate for bed level but not sufficiently to lay down a good first layer. As the photo shows in the Y+ direction the nozzle is too close and…
-
Hi Guys
I tried enable auto bed level function in my marlin RC4, but leveling this not working properly.
Check my picture below
http://imagens.abcdotecnico.com.br/images/129101121162274300473623445…
-
Here's the problem I'm seeing from Marlin:
When attempting to home all axes, whether AUTO_BED_LEVELING_FEATURE is enabled or not,
on RC3: the machine homes X, homes Y, then stops.
on RC2: the mach…
-
Hi, first of all, you boys doing a excellent job.
I need help with auto bed leveling calibration. When it was manually calibrated, printer works great, the print quality of first layer is excellent. …
-
### Did you test the latest `bugfix-2.0.x` code?
Yes, and the problem still exists.
### Bug Description
After reboot the part cooling fan works without problems - and its speed is controlla…
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
While setting the Z_MIN_POS to negative value ( i.e. -0.8mm) then do the auto homing using 3D/BL tou…
-
Hi all
I can not understand why the auto bed leveling not level correctly and not center the object on the bed, but has an offset (I did not understand where to change it).
As you can see in the foll…
-
Hello,
I got a stupid question, after my delta executed G28/G29, the result is unsatisfactory, as this situation, should I run G29 again or any other methiod?Thanks
-
Hi everyone,
I have a problem with my auto bed leveling. I have a delta printer and I use the grid leveling mode. Everything seems to work if I execute the G29 code. But if a execute the G29 code and…
-
What is the different between both, because from the description standpoint seems bilinear more complex than linear. But in compile size is linear more than 9000 bytes bigger. Any idea why?