-
Have a Z8T that I upgraded to use zm3e4 (v 1.0) board, the Zonestar wifi module (from Zonestar _official store on AliExpress,) 2208 steppers for all motors, and LCDDWIN (from same store) and using fir…
-
It would be useful to see the wiring schematic you used for this project. Perhaps you could add it to README.md?
Edit: Also, I'm confused. Does this let us also program cheap Ebay knock offs to loo…
-
Hi! Is this something similar to https://github.com/kmonad/kmonad ?
-
You might want to include any of this as a caveat to your 'DDs shipping' comments:
Don't trust microchipdirect's availability or ship dates on the avr32dd14 (and probably other DDs).
I had order…
-
First off, thanks for this great little utility, I am leaning a ton.
When I attempt to compile for other than AVR, I get a sprinkle of these errors.
"invalid conversion from 'char' to 'ZEPPP_RET…
-
### Describe the bug
I have a new board SAMD21 M0 size as Arduino UNO, compatible with Arduino M0, native port, with ethernet shield Wiznet W5100.
I tried example code Hello World, edit all serial…
-
So, for a test, I tried to attach a serialupdi to my Curiosity Nano with an AVR128DB48.
Just in case, I cut the connection between the onboard debugger and the UPDI pin on the CNano.
I then attached…
-
Transferring gcode to an SD card over the USB connections has always been too slow to be practical. Normally, the card is moved to the computer to transfer the gcode, before moving it back to the prin…
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
I Have a Genuine Mega2560 powered 3dprinter using TMC2209's in UART mode on an RAMPS1.4 EFB setup. I…
-
Basicly I have some ATTiny 412 chips. When I program it by UPDI, it shows the following error:
```
pymcuprog.serialupdi.application - INFO - Device ID from pyupdi = '1E9221' rev 'B'
pymcuprog.nvm -…