-
**Describe the bug**
While trying to publish a speed command via MQTT, spaces may cause the command to be ignored.
**To Reproduce**
Steps to reproduce the behaviour:
1. mqtt pub -t itho/cmd -m '…
-
The pinout for this device is different as the SX1278 is hardwired.
GPIO5 -- SX1278's SCK
GPIO19 -- SX1278's MISO
GPIO27 -- SX1278's MOSI
GPIO18 -- SX1278's CS
GPIO14 -- SX1278's RESET
GPIO26 -…
-
Hi,
I am trying to decode the RainPoint sensor ( https://github.com/merbanan/rtl_433/blob/master/src/devices/rainpoint.c ) using low cost RXB6. I can get data from it but it's not correctly decoded. …
-
I connected an Arduino with a CC1101 and evofw3 on the Raspberry on which I run home assistant (2022.12.4).
Since I just started I only configured it as follows:
`ramses_cc:
serial_port: /dev/t…
-
I connected an Arduino with a CC1101 and evofw3 on the Raspberry on which I run home assistant (2022.12.4).
Since I just started I only configured it as follows:
`ramses_cc:
serial_port: /dev/t…
-
Hi,
what is the range of SX127x?
I use CC1101 from Ebytes and a few low cost sensors(weather station, rain bucket, soil moisture) but the range is around 20 meters on open field and less than 10…
-
### PROBLEM DESCRIPTION
Sonoff devices after upgrade to Tasmota 12.0.2 reboot every ~20 minutes with StatusSTK":{"Exception":29,"Reason":"Exception","EPC":["40252ca8",...
### REQUESTED INFOR…
-
Hi, nice work!
But could you provide some minimal example to write/output throught the cc1101 please.
-
I purchased the non-cve addition for the above ITHO unit (approx 12 years old). After connecting with ethernet cable the led on the eth. port is blinking and after a couple of seconds one led is blink…
-
I found your project when looking around the Share Your Projects forum on the Home Assistant site. I am using the nodejs Pool Controller and its associated HA integration & have been very happy with …