-
After some time of uptime on the Raspberry Pi 3 we're seeing a crash with 4.10 in the i2c_bcm2835 driver. The RPI2 is stable. It happens even on a minimal install with no GUI running.
The crash I c…
-
Dear Authors,
Thank you for your great work! I obtained CSI at about the rate of about 50 frames per second. It there anyway to obtain faster CSI copy channel?
A. Does these two SPRs have the free…
-
Hi esp
I loaded the driver.But there's no device in sight.What's going on?
root@maaxboard8ulp:~/test#
root@maaxboard8ulp:~/test#
root@maaxboard8ulp:~/test#
root@maaxboard8ulp:~/test# insmod es…
-
When I run ./face_detection_camera.py, after a minute I get this dump and then it exits immediately if I try to run it again with the same erro..
```
Iteration #3477: num_faces=0
Traceback (most …
-
### Describe the bug
Hi!
I have built a yocto-image for my CM4, and I'm using linux 5.15.32 from this repository. The CM4's USB2 lines are connected to a FE1.1S 4port hub.
I am normally seeing …
-
When I try to start mupen64plus with the bot I get this error: `Input Error: ERROR, no such host ''` Without the bot everything works fine. I have tried to change the host in the config file but I get…
-
Hi, we've been testing SEV for a few weeks now and hope someone can help us move forwards.
Thank you in advance.
## Table of contents:
| Section | Link …
-
When I issue the command "sudo python3 visualization.py scroll" I get an error
Traceback (most recent call last):
File "/home/pi/dancyPi-audio-reactive-led/python/visualization.py", line 418, in…
-
```
sudo modprobe sprdwl_ng
```
Call trace:
```
[ 87.556932] __dev_change_flags+0x170/0x1c8
[ 87.561128] dev_change_flags+0x2c/0x70
[ 87.564976] do_setlink+0x654/0xd98
[ 87.568478] …
katyo updated
2 years ago
-
This command will build in test mode (requires the `test` crate or some other test harness), and run the test binary in an emulator like `cen64`.
The emulator and its command line args will be spec…