-
```
My CPU's FSB is 200 MHz, Open Hardware Monitor 3.2 and 4.0 both sometimes show
incorrectly 190 MHz. Sometimes it is displayed correctly: When Open HW Monitor
starts while CPU utilization is high…
-
```
My CPU's FSB is 200 MHz, Open Hardware Monitor 3.2 and 4.0 both sometimes show
incorrectly 190 MHz. Sometimes it is displayed correctly: When Open HW Monitor
starts while CPU utilization is high…
-
```
My CPU's FSB is 200 MHz, Open Hardware Monitor 3.2 and 4.0 both sometimes show
incorrectly 190 MHz. Sometimes it is displayed correctly: When Open HW Monitor
starts while CPU utilization is high…
-
```
My CPU's FSB is 200 MHz, Open Hardware Monitor 3.2 and 4.0 both sometimes show
incorrectly 190 MHz. Sometimes it is displayed correctly: When Open HW Monitor
starts while CPU utilization is high…
-
```
My CPU's FSB is 200 MHz, Open Hardware Monitor 3.2 and 4.0 both sometimes show
incorrectly 190 MHz. Sometimes it is displayed correctly: When Open HW Monitor
starts while CPU utilization is high…
-
We need to swich power off spi slave when not used. This causes slave cs pin go ground while host cpu cs is high(because cs is active low) This causes power consumption.
We are currently not found …
-
I'd like to have an optional setting **`nice=`** in the `[program:x]` section that would start a program with a certain niceness value. It would be an integer between -20 (high CPU priority) and 19 (l…
-
### What happened?
in current kubelet below algorithm, the pods/containers shall be affinity to different numa node unbalanced.
for example: if there is 6 pods with integer cpu container config…
-
1. I'm using spark-operator(v1beta2-1.2.3-3.1.1) with volcano (v1.3.0), and spark-operator is installed with batchScheduler enabled. When applying following sparkapp to a machine with 16 cpus, I expec…
-
The _phocube_ program of ISIS is running **too slowly**. I noticed in the system monitor that **its CPU usage is very low, and the memory usage is only around 30-50 MB**. However, my actual system has…