-
Built out the pico and display as per the schematic and loaded a test app up on it with latest release CP. Reported no device at 0x70. After a long tear down and comparison with a Feather based config…
-
### Description
I observed this heating phenomenon for quite a while. I saw some mentions in other bugs and mine as well. I decided to watch it closely.
At first, I thought it was related to battery…
-
* ReaR configuration files ("cat /etc/rear/site.conf" and/or "cat /etc/rear/local.conf"):
* OS is debian11
1. is there certain sequence for the variables in /etc/rear/local.conf?
2. the output …
-
After updating my system to Ubuntu 22.04 I can connect anymore to your ESP32-POE board:
```
[ 4026.435289] usb 1-2: new full-speed USB device number 8 using xhci_hcd
[ 4026.584263] usb 1-2: New USB…
ghost updated
2 months ago
-
I have a problem with the quality of the recorded audio, I have tested in 2 computers with the same device. The computers have one integrated soundboard with no microphone attached, and a USB Andrea d…
-
hello
How to virtually connect jpcsp via usb cable?
In newest revisions is such function, but i not know, how to enable it.
There is no configuration in gui.
ghost updated
2 years ago
-
Hello,
I setup chinese Nano 3.0 board with esp-link controller and everything works like charm. Then i tried to replace Nano with chinese 'micro' boards on 32u4 chip and none of them is accept firmwa…
-
Deletion of the wireless interface results in endless hang of `iw` process which could not be killed even with `kill -9` and makes the device unable to operate normally due to hangs on any operations …
-
My rust dev env is set up in WSL, I plug my rp pi pico and windows surely detects it.
However, the elf2uf2 depends on sysinfo to dectect the pico uf2 disk.
This is fine if you set up the rust env …
-
```
I've had two conrad branded of these sitting around for a while and finally
wanted to see if I can get snake on them.
Specs:
SoC: CNS2183
RAM: 32MB
Flash: 1MB EN25F80
There are two rows of head…