-
hi biqu/bigtreetech and dev-users hereoff
i have a hermitcrab v1 that connects to a btt pi2 through the BTT RPI-CAN HAT V1.0 CAN module.
but i can't get a connection trough.
i tryed it because …
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Hello, dear Marlin community
I´ve discovered a strange behavior when I was trying to impro…
-
Hello.
After installing and flashing my Eddy USB and build up my printer i want to Calibrate the EDDY and got this error:
"Error on 'PROBE_EDDY_CURRENT_CALIBRATE': missing CHIP"
BTT Justin, I w…
-
I tried to run 3.5 inch LCD with driver ili9488 in 4-line SPI mode on fbtft overlay, but this driver (ili9488) does not support RGB565 mode in 4 line SPI. If driver init with RGB666, then i`m take wro…
-
I brought a new SKR2 rev B with 5x tmc2226.
I connected the board directly via USB and configured, installed new firmware, etc... After that, I replaced my old board with this SRK2 but the board refu…
-
I had uploaded marlin 2.0 firmware on my Bigtree tech SKR PRO V1.1 board successfully and connected with pronterface and checked the motor orientations. Next day I am about to do the PID tuning, but t…
-
I have
- skr-pro 1.1
- last Marlin 2.0
- LCD 12864 - (works with last Marlin 2.0)
- ESP01S with last ESP3d web interface works, baudrate=250000
configuration.h
#define SERIAL_PORT -1
#defi…
-
I have an btt skr mini e3 v3 with marlin 2.1.1 and a tft35 e3 v3 running on my artillery sidewinder x1. When using the sdcard slot or usb port on the tft, i get random freezes during the print. i have…
-
Please supply them is you want to sell this board...
-
hi I'm very new to this
I have this problem, the z-axis does not move to the maximum position I already tried with G-code commands from pronterface, tried from the touch screen terminal, and tried fr…