-
Dear, ikostoski
I am grateful for your wonderful work.
I also want to recycle the use of the old CLGLCD, but I need to use ESP32.
How can I configure your library for perfect use?
I searched on…
-
### Description
The stock start gcode for the Taz 6 includes the G26 to "clear potential 'probe fail' condition". It appears Marlin now uses it to validate the bed leveling mesh.
### Steps to…
-
Perhaps this is a feature rather than a bug, but I am running in to an issue that text is being rendered below the cursor (i.e. under the Y coordinates), rather than above.
I am using an ILI9341 …
-
**the bug**
I was testing a board outdoors running on a battery and solar panel, using ECO mode set at 1800 seconds (30 min) After several days I switched the board to go into ECO mode for 3600 sec…
-
```
Attached to this post is a new font, its 3x5 and full alpha numeric.
It is based in the Wendy font from dafont.com with a lot of changes made to it.
A really small font included in the library, so…
-
```
Attached to this post is a new font, its 3x5 and full alpha numeric.
It is based in the Wendy font from dafont.com with a lot of changes made to it.
A really small font included in the library, so…
-
```
Attached to this post is a new font, its 3x5 and full alpha numeric.
It is based in the Wendy font from dafont.com with a lot of changes made to it.
A really small font included in the library, so…
-
```
Attached to this post is a new font, its 3x5 and full alpha numeric.
It is based in the Wendy font from dafont.com with a lot of changes made to it.
A really small font included in the library, so…
-
Following Errors come while compilation
GetFileAttributesEx E:\Arduino\libraries\SD\src\File.cpp E:\Arduino\libraries\SD\src/SD.h: The filename, directory name, or volume label syntax is incorrect.
…
-
Hi.
What's with the re-init of LCD at contactor open and close functions? Surely, this is a quick patch not a solution. I'm volunteering to fix the HW issue causing this to be needed, if someone can …