-
I wanted to try to swap LCDs to use a bigger 128x64 display on my Prusa i3 MK2. Considering it was Marlin firmware, I thought it would just be commenting and uncommenting a few lines. However, it seem…
-
### Bug Report
- Description:
I'm struggling very badly to make my extruder motor behave properly since the introduction of linear advance 1.5.
It is consistantly underextruding while printing, a…
-
Hi, first of all sorry for my bad english, and thanks
I open another thread because the old oine has been closed
But anyway I have the same problem, My printer is ignoring the endstop
If the logic …
-
Please provide *general* feedback on your experience with the 1.4.0rc3 Release Candidate here. An "All is working fine" is valuable feedback as well, because it tells me that people in fact are testin…
-
### Version
_2.2.0
### Operating system type + version
_Windows 10
### 3D printer brand / version + firmware version (if known)
somewhat a Prusa i3 MK3S bear upgrade with duet wifi board
H…
-
So, I've got two different MKS sbase boards. One of which I've used with smoothie for well over a year now, the other was an unused backup. Every commit of marlin I've tried over the last month has ha…
-
Hi,
I've noticed you don't have a blur shader in the MPC-HC's shader list.
Other players, like Potplayer and VLC, have the ability to add blur to the picture, out of the box.
I use this featur…
-
**Application version**
4.6.1
**Platform**
Windows 10 64 Bit
**Printer**
Anycubic i3 Mega
**Reproduction steps**
1. Loaded the "cartridge_holder.stl" file into Cura from here:
2. Ena…
-
**Application Version**
20191228
**Platform**
Windows 10
**Printer**
Anycubic i3 Mega, project file and screenshots attached
**Steps to Reproduce**
I don't know. I have disabled all plugi…
-
**Application version**
Cura 4.6.1
**Platform**
Windows 10 (64 Bit)
**Printer**
Anycubic I3 Mega S
**Reproduction steps**
1. Designing a plain circle (e.g. 0.1mm in height)
2. Proces…