-
hi sandeep,
I am using two SX1276RF1IAS transceivers and using this code but every time it gives error Lora failed. i am using arduino uno board.
please help???
-
what can be problem?
-
I'm utterly sorry for writing about datasheet questions/errata here. Twice I was rejected from Semtech LoRa Community Forum registration then I tried to send these same questions to lora_community_sup…
-
Hi,
I'm trying to communicate an arduino and a raspberry Pi through two RA-02 lora modules. I am using the RadioHead library in the Ardino and I'm trying to use this python library on the side of Ras…
-
Hello, I urgently need a library to build homematic devices, which are not available by Homematic.
I was happy to find AskSin or AskSinPP.
I need to work with ESP (Espressif) MCU's preferable ESP32 …
-
Hello !!!
I am using two Arduino UNO and two Lora Ra-01 module.
As per your instruction, I connected all of the wire to my UNO, But it couldn't be worked. Then I put one another wire in between Dio…
-
Has anyone tried to decode signals from a LoRaWAN network, like the TTN, with this plugin?
LoRaWAN (with a few exceptions) uses the 125 kHz bandwidth, coding rate 5/6, explicit header, CRC on, SF var…
-
There's a comment in sx1276.c claiming
> // REMARK: When using LoRa modem only bandwidths 125, 250 and 500 kHz are supported
at this line: https://github.com/Lora-net/LoRaMac-node/blob/master/s…
-
I have looked at your code and I cannot see where the LowDataRateOptimize flag is being set, or can be set ?
See section 4.1.1.6 of the SX127x datasheet, the flag (bit 3 of reg 0x26) needs to be se…
-
The adsb-receiver project is a set of scripts/rasperbian image to package up various ADS-B data decoders and feeders, which is now expanding to add support for other similar protocols such as the Open…