-
On a Nano Every, if you try and transfer more than about 128 characters from the Serial Monitor to the board via the serial interface it locks up, and the only solution is to unplug the USB cable.
…
-
The ones that show up under Tools -> Boards -> Arduino megaAVR Boards.
Re:
https://forums.adafruit.com/viewtopic.php?f=19&t=158099
Guessing this just needs some tweaks to the preprocessor logi…
-
Hi, I'm holding on porting JTAG2UPDI for the 32U4. The 32U4 (leonardo) is used for programming ATtiny via UPDI. While receiving data via USB (mapped to COMx) the 32U4 cannot send feedback to the Ardui…
-
Hi, when using SW SPI constructors on a Arduino NANO EVERY (atmega4809) i've noticed very poor performance (flickering an slow screen redraws) compared with the same layout on a Arduino NANO V3 (atmeg…
-
Arduino: 1.8.10 (Mac OS X), Board: "AI Thinker ESP32-CAM"
WARNING: library Servo claims to run on avr, megaavr, sam, samd, nrf52, stm32f4 architecture(s) and may be incompatible with your current b…
-
I'm trying to make my Uno wifi rev2 set up using MQTT with node-red.
I thought I had it configured right but then it gives me this error.
I have connected before with open security instead of WPA2.
…
-
Current the core and it's libraries are flash hogs. This is problematic on the smaller ATtiny parts. We now create the assembler listing when dumping the compiled binary, so we have the tools we need …
-
Can you add support for the new megaAVR 0-series boards, like Arduino Wifi Rev. 2,
ATmega4809-XPRO (ATMEGA4809-XPRO) and ATmega4809 Curiosity Nano Evaluation kit.
The last costs under 10€ inclusive …
-
Hi,
Not sure if here is the correct place to write ...
Maybe a little tutorial to setup with Mega2560 Pro Embed?
Looking the new code and my MegaDuino project design ... my pins are:
```
…
-
I have installed 1.1.1, but ..
" In file included from C:\Users\lcagl\AppData\Local\Arduino15\packages\megaTinyCore\hardware\megaavr\1.1.1\cores\arduino/UART.h:28:0,
from C:\Use…